Ankarmassa Vinylester Sormat ITH-VE

Anchor compound Sormat ITH VE: Styrene-free vinyl ester compound. High-performance injection compound of vinyl ester for threaded rod/reinforcement in cracked and uncracked concrete.
European technical assessment ETA-13/0774; Option 1 (Cracked concrete) = M12 - M30 / Ø 12 - 32
European technical assessment ETA-13/0774; Option 7 (un-cracked concrete) = M8 + M10 / Ø 8 + 10
European technical assessment ETA-13/0775; for subsequent assembly of rebar (EC2 / TR 023)

Sormat ITH-Ve is an almost odourless, fast-curing injection compound with extra high performance. Injection compound ITH-Ve is suitable for use in concrete and stone. Suitable with small edge distances e.g. attachment of facade cladding, recess bars, pin bolts for steel columns and ground bolts. Can be used in damp holes and under water. Thanks to extremely little shrinkage, the compound is specially suited for injection in connection with recess with reinforcement bars. ETA approvals also apply to reinforcement bars Ø8 - 32 mm. Low VOC content. Fire class F120. Storage +5 °C...+25 °C. Temperature resistance-40 °C...+120 °C. NSF drinking water certified. LEED tested.

Leave the mixing pipe on on partially used cartridges. Replace the mixing pipe before re-use. 2 x mixing pipes are included with each cartridge. The 300 ml cartridge can be used with standard silicone gun.

Installation in solid materials: Drill a hole according to the assembly data in the table. Diamond-drilling holes must be buffed. Clean the hole carefully from drill dust with a brush and blow pump. We do not recommend cleaning the hole with water because this would double the curing time. Fill up the hole to 2/3 with injection compound. Turn down the anchor rod manually and rotate it a few times in order to make sure that the compound has been distributed around the anchor rod. Note the curing times before applying load on the anchor. Install the detail to be secured by tightening the nut to the recommended
tightening torque, which can be found in the table.

I) Open time period, before a chemical reaction (curing) starts. Curing time: before load can be applied on the anchor in a dry environment.

II) Assembly data and capacity values for solid base materials:
Anchor bar and fully threaded rod, steel grade 5.8 in uncracked concrete C20/25. Cross load values apply to attachment without concrete edge impact. The values in brackets () apply to cracked concrete.

III) Assembly data and capacity values for solid base materials:
Reinforcement bar grade A500HV in uncracked concrete C20/25. Cross load values apply to attachment without concrete edge impact. The values in brackets () apply to cracked concrete.